Free Manual

Uniden PC68XL CB Radio Manual

CONNECTING THE POWER CORDS We recommend connecting the power lead to the Ignition Switch Accessory Terminal. This way, the transceiver is automatically turned off when the ignition switch is turned off. Or, the power cord may be connected to an available terminal on the fuse block, or, to a point in the wiring harness. However, caution must be taken to prevent a short circuit. If in doubt, contact your vehicle dealer for information.

Negative Ground System

If you have a negative ground system, connect the red DC power cord from the transceiver to the positive (+) battery terminal or other convenient point. Then connect the black power cord to the vehicle chassis or negative (-) battery terminal.

Positive Ground System

If you have a positive ground system, connect the black DC power cord from the transceiver to the negative (-) battery terminal or other convenient point. Then, connect the red power cord to the vehicle chassis or the positive (+) battery terminal.

GROUND INFORMATION

Most newer U.S. and foreign made cars, and small trucks, use a negative ground system. Some older cars, and some new large trucks, use a positive ground system. With a negative ground system, the negative (-) battery terminal is usually connected to the vehicle motor block. If you cannot determine the polarity system of your vehicle, contact your vehicle dealer for information.

Download Uniden PC68XL CB Radio Manual