Sunday, September 16, 2012
Volvo Penta MD11C D MD17C Manual Repair
Volvo Penta MD11C D MD17C Manual Repair Methods of work described in the manual of service shall apply to the work carried out in the workshop. The engine was removed from the boat and is installed in the engine support. Tighten torque-protractor (angle). Not nuts for locking of reuse, which were removed during the dismantling, they have reduced service when used again-use new nuts where the installation or reinstallation.
Guide to: Stop drive screw bleed air, Bilge pump, supply tube nut, locking-screw, crankshaft Center liaison. . Pressure equalizing valve oil pressure sender. PISTONS AND CONNECTING RODS. The removal of verification of the crankcase cover (6 mm socket head). MD17: Remove the oil sump and strainer. Remove the carrier of the crankshaft.
